sled-sony-rc-shutter-v2 View larger

SLED SONY RC SHUTTER v2

sLed sony

New product

NEW sLED v2 SERIES

More details

$14.90

Add to wishlist

By buying this product you can collect up to 3 loyalty points. Your cart will total 3 points that can be converted into a voucher of $0.27.


    NEW sLED v2 SERIES
    Previous sLED shutters was using 5mm standard IR LEDs to emmitting the signals.
    Our new sLED v2 boards including onboard SMD IR LED for lighter, better and stronger design.
    You can also attach it to IR window of your camera with a sticky tape. 

    Weight: 4gr
    Voltage: 3-7 volts
    Current: 2mA
    Cable Length: 30cm
    Accepting Signal: 1-2ms PPM over servo line.

    USING sLED

    • Just plug it to your receivers'a any empty channel.
    • Use a 3 position switch, knob, stick or logical switch for controling the modes.
    • Configure your SONY for IR Remote. 
      You can find the remote control menu under DRIVE MODES of Nex5 machines.
      If you are using other models please check the menu system to enable IR Remote mode.


    Control Modes
    CENTER position: Idle mode of sLED
    UP Position:  Photo Shot
    DOWN Position: Video Start/Stop

    Compatible Models: 


    Whole ALPHA series SONY machines.
    NEX-7
    NEX-5,
    SLT (A77 A65 A57 A55 A33),
    DSLR (A900 A850 A700 A580 A560 A550 A500 A450 A390 A380 A330 A290 A230)
     

    Note 1: Your model may not be included in the above list. Please check the manual of you camera to see whether it is compatible with IR video start/stop option. Our remote shutter compatible with RC-1 and RC-6 remote shutters of Canon.

    Note 2: You should enable "IR remote" mode from your Sony's video menu before using this device.  You can find the remote control menu under DRIVE MODES of your Nex5 machines. If you are using other models please check the menu system to enable IR Remote mode.

Reviews

Write a review

SLED SONY RC SHUTTER v2

SLED SONY RC SHUTTER v2

NEW sLED v2 SERIES

2 other products in the same category: