Latest version of legendary SimpleOSD.
And the size is smaller than previous SimpleOSD versions.
The concept of SimpleOSD is "flying like a bird without OSD scraps on the screen"
This is why SimpleOSD uses smallest fonts and has only 1 line OSD information on top with out default firmware.
By the way the hardware is open source. You can write your own code or upload other compatible OSD codes into the hardware with a standard FTDI Cable.
Working with both DIY-OSD(open source) and SimpleOSD XL(close code) firmwares. (compatible SimpleOSD XL firmware coming soon)
16Mhz Atmega328 Processor with Arduino Boot
Standard 6 Pin FTDI Port for PC connection and other Serial sensors as GPS
100% compatible with DIY-OSD Project.
On-Board Voltage Sensor
One current sensor input
Simple 3 pin (video,+,-) connection to video system.
I2C pins ready to solder for all sensors.
4 extra Analog input pin
6 extra Digital input pin
5V regulated output for other sensors (120mA max)
Build-in LM1881 video signal seperator
PAL & NTSC compatible
5v FTDI cable or any USB to TTL cable that compatible with Arduino
Latest version of Arduino Software for your operation system.
DIY OSD source codes for modifying or uploading.
Loading the DIY-OSD Firmware:
Run the Arduino Software
Open DIY OSD code (File>Open)
Select right com port from your computer (Tools>Serial Port)
Select right target device (Tools>Board>Arduino Pro or Pro Mini 5V,16Mhz with Atmega328)
Connect the FTDI cable to SimpleOSD X2
Press the load button of software and wait for done.
*If any problem about Arduino Software, you can follow their community forums.